upvc Wye 6″

Description

upvc Wye 6″

 

GM made in Pakistan ASTM uPvc Sch-40 Pressure Fittings, Drain sewer ventilation. best quality fittings in Pakistan Supplier contact 0322-3540656

 

What is upvc Wye 6″ GM ?

 

Description:

A UPVC (Un plasticized Polyvinyl Chloride) Wye fitting with a 6-inch diameter, designed for pressure applications. “GM” typically refers to “Gasket Male” or “Gasket Male Threaded,” indicating the type of connection. These fittings are used to connect pipes at a branch angle (usually 45°) to main pipes, allowing for smooth flow diversion.

---

2. Specification:

• Material: UPVC (Unplasticized Polyvinyl Chloride)
• Size: 6 inches (nominal diameter)
• Schedule: Sch 40 (Schedule 40), indicating the wall thickness suitable for pressure applications
• Type: Wye fitting (Y-shaped connection)
• Connection Type: GM (Gasket Male) or as specified
• Standards: Often conform to ASTM D2466, ISO 1452, or other relevant standards
• Pressure Rating: Typically rated for up to 150 psi (varies with manufacturer)

---

3. Features & Benefits:

• Corrosion and chemical resistant
• Lightweight and easy to install
• Smooth interior surface for minimal flow resistance
• Durable for underground and above-ground applications
• Cost-effective alternative to metal fittings

---

4. Usage:

• Sewage and drainage systems
• Industrial waste piping
• Chemical processing pipelines
• Water supply systems
• Vent and venting applications

 

---

5. Installation Guide:

Tools & Materials Needed:

• PVC solvent cement and primer
• Pipe cleaner
• Measuring tape
• Marker
• Protective gloves and eyewear

Steps:

1. Preparation: Measure and mark the pipe sections where the Wye fitting will be installed.
2. Cleaning: Clean the pipe ends and fitting socket with a pipe cleaner to remove dirt and grease.
3. Priming: Apply primer to the outside of the pipe end and the inside of the fitting socket.
4. Assembly: Quickly insert the pipe into the fitting socket, twisting slightly to ensure even distribution of cement.
5. Hold: Hold the connection in place for a few seconds to allow the cement to set.

Note: Ensure proper alignment and support to prevent stress on the joints.