Euro Gulf Elbow 3″ 45*

Description

Elbow 45 degree 3″ upvc

 

Euro Gulf local Distributor Suppliers in Karachi Contact 0321-2248975 ASTM uPvc Sch-40 Pressure Fittings, Drain sewer ventilation

 

What is Euro Gulf Elbow 3″ 45* ?

 

The Euro Gulf 3″ 45° Schedule 40 Elbow is a high-performance piping component used primarily in pressure applications. While “Euro Gulf” produces both UPVC and CPVC, the Schedule 40 designation in a 3-inch size typically refers to their UPVC (Un plasticized Polyvinyl Chloride) line for cold water or CPVC for hot and cold systems.

---

1. Detailed Information & Description

An elbow is a “directional” fitting. A 45° angle is often preferred over a 90° angle in HVAC and water supply because it reduces friction and “head loss,” allowing fluid to move more efficiently with less turbulence.

• Brand: Euro Gulf (A leading manufacturer in the Gulf/Middle East and Pakistan regions).

• Type: Schedule 40 (Standard Wall Thickness).

• Angle: 45 Degrees (1/8 Bend).

• Joint Type: Solvent Weld (Slip x Slip). This requires chemical solvent cement to create a permanent bond.

   

---

2. Technical Specifications Euro Gulf Elbow 3″ 45*

Feature	Specification
Nominal Size	3 Inches (Nominal Pipe Size)
Outside Diameter	~88.9 mm
Material	UPVC (White) or CPVC (Light Grey/Tan)
Standard	ASTM D2466 (for UPVC) / ASTM F441 (for CPVC)
Max Temperature	UPVC: 60°C (140°F) | CPVC: 93°C (200°F)
Pressure Rating	Approx. 260 PSI at 23°C (Rating drops as temperature increases)
Color	White (Cold Water/Drainage) or Tan/Light Grey (Hot Water)

---

3. Usage & Applications

• HVAC Systems: Used in chilled water lines and condensate drain lines. The 45° bend is excellent for routing pipes around structural beams without significantly dropping the pressure.

• Hot & Cold Water Supply:

  • Cold Water (UPVC): Main water distribution lines in buildings.

  • Hot Water (CPVC): If specifically marked as CPVC, it is used for boiler lines and hot water distribution.

• Industrial: Transport of chemicals or treated water where metallic pipes might corrode.

---

4. Installation Guide

1. Preparation: Cut the 3″ pipe square using a fine-tooth saw or pipe cutter. Remove all burrs from the inside and outside edge.

2. Dry Fit: Insert the pipe into the 45° elbow to ensure it goes in at least 1/3 to 2/3 of the way into the socket.

3. Cleaning: Use a specialized pipe cleaner/primer on the outside of the pipe and the inside of the elbow socket. This “softens” the plastic for a better bond.

4. Cementing: Apply a liberal coat of Solvent Cement to the pipe and a thin coat to the elbow socket.

5. Joining: Quickly insert the pipe into the elbow and give it a quarter-turn to distribute the cement evenly.

6. Set Time: Hold the joint firmly for 30 seconds. Allow at least 2 hours (depending on weather) before pressure testing.

---

5. Important Considerations

Temperature Check: If your system involves “Hot Water Supply,” verify the fitting is CPVC. Standard White UPVC Schedule 40 will soften and fail if exposed to temperatures above 60°C for extended periods.