AGM upvc End Cap 3/4″

Description

upvc end cap 3/4″

 

AGM imported from Saudi Arab ASTM uPvc Sch-40 Pressure Fittings, Drain sewer ventilation. distributor in Pakistan contact 0322-3540656

 

What is AGM upvc End Cap 3/4″ ?

 

AGM UPVC End Cap 3/4″ Schedule 40 is a solvent-weld fitting manufactured by Arabian Gulf Manufacturers (AGM) in Saudi Arabia, designed for capping the ends of UPVC pipes in pressure, drainage, sewerage, and water supply systems. These fittings conform to ASTM D2466 standards for Schedule 40 PVC pressure/DWV applications and are produced using high-quality SABIC UPVC raw materials with rigorous quality controls.​

Product Description

AGM UPVC End Caps seal pipe ends securely in plumbing systems, preventing leaks and contamination. Imported from Jeddah, Saudi Arabia, they suit residential, commercial, and industrial uses like water supply, sewerage, drainage, and ventilation. The light gray fittings offer advantages including lightweight design, low friction, watertight joints, corrosion resistance, and flame retardancy up to 80°C.​

Specifications

• Nominal Size: 3/4″ (outside diameter 1.050 inches or 26.67 mm).

• Schedule: 40 (minimum wall thickness 0.113 inches or 2.87 mm; average internal diameter 0.824 inches or 20.93 mm).

• Material: Un plasticized Polyvinyl Chloride (UPVC), ASTM D1784 Cell Class 12454.

• Pressure Rating: 480 PSI at 23°C (includes 2:1 safety factor); derates at higher temperatures.

• Standards: ASTM D2466 (Sch. 40 fittings), ASTM D2774/D2855 (solvent weld joints); suitable for DWV per ASTM D2665 for sizes 1¼” and up, applicable here for pressure systems.​

• Color/Length Compatibility: Light gray; pairs with 6-meter AGM UPVC pipes.​

Applications

These end caps work in cold water supply, sewerage, drainage, waste/ventilation, and non-pressurized HVAC lines. They resist chemicals, biofilms, and environmental stress without corroding, ideal for imported quality in Middle East-sourced projects.​

Installation Guide

Cut pipe square with a 15° bevel on the end. Apply UPVC primer to pipe and socket (scrub 2-3 coats), then solvent cement in a circular motion—first to pipe (to socket depth), then socket, and reapply to pipe if over 1¼”. Insert pipe into cap socket with ¼ turn, align, and hold 30 seconds; cure fully before pressure testing. Use AGM adhesives for molecular fusion; avoid skin contact and ensure ventilation.