Description
upvc elbow 1/2″ 45*
AGM imported from Saudi Arab ASTM uPvc Sch-40 Pressure Fittings, Drain sewer ventilation. importer distributor dealer contact 0322-3540656
What is AGM upvc Elbow 1/2″ 45* ?
The AGM UPVC Elbow 1/2″ 45° Sch 40 is a high-quality pipe fitting designed for various plumbing and piping systems, including HVAC, sewerage, and water supply. Below is a detailed overview covering its information, description, specifications, installation, and usage.
Product Overview
Product Name: AGM UPVC Elbow 1/2″ 45° Sch 40
Material: UPVC (Un plasticized Polyvinyl Chloride)
Size: 1/2 inch (for smaller piping systems)
Angle: 45 degrees
Schedule: Sch 40 (Standard wall thickness)
Origin: Imported from Saudi Arabia
Description AGM upvc Elbow 1/2″ 45*
The AGM UPVC 45° elbow fitting is a molded or fabricated pipe component that redirects the flow of liquids or gases by 45 degrees within a piping network. Made from UPVC, it offers excellent chemical resistance, corrosion resistance, and durability. Its Sch 40 specification indicates it has a standard wall thickness suitable for moderate pressure systems.
This fitting is commonly used in:
- HVAC systems for air and water distribution
- Sewerage pipelines for waste and drainage
- Potable water supply lines
The 1/2″ size is suitable for smaller or residential plumbing systems.
Specifications
| Parameter | Details |
|---|---|
| Material | UPVC (Un plasticized Polyvinyl Chloride) |
| Size | 1/2 inch |
| Angle | 45 degrees |
| Schedule | Sch 40 (Standard wall thickness) |
| Pressure Rating | Typically up to 150 PSI (varies with standards) |
| Temperature Range | -5°C to 60°C (23°F to 140°F) |
| Imported From | Saudi Arabia |
| Standards Compliance | ASTM D1785, IS 12818, DIN 8062 (depending on manufacturer) |
Installation
- Preparation:
- Ensure pipes and fittings are clean and free from debris.
- Check the fitting for any damages or defects.
- Fitting Connection:
- Use PVC solvent cement suitable for UPVC pipes.
- Apply primer if necessary to soften the surface for better adhesion.
- Apply solvent cement evenly to both the pipe end and the fitting socket.
- Assembly:
- Insert the pipe into the elbow socket, ensuring proper alignment.
- Push firmly and twist slightly to evenly distribute the cement.
- Hold in place for a few seconds to allow the cement to set.
- Curing:
- Allow the joint to cure as per cement manufacturer’s instructions before pressurizing the system.
Usage
- HVAC Systems: To route air or water lines around corners and obstacles efficiently.
- Sewerage & Drainage: To change flow direction in waste and vent pipes.
- Water Supply: To navigate piping through buildings or underground installations.
Advantages
- Corrosion and chemical resistance
- Lightweight and easy to install
- Long-lasting with minimal maintenance
- Suitable for underground and above-ground applications
Additional Notes
- The 1/2″ UPVC elbow is ideal for small diameter piping systems.
- For larger sizes (like 8″), similar fittings are available but designed for higher flow volumes and pressure ratings.
- Always verify compatibility with your piping system standards and local codes.
Reviews
There are no reviews yet.